ZT MK2
Safety rules
19
www.zepro.com
3.7
Adjustment of slide profiles
The position of the slide profiles on the support frame has to be adjusted to the vehicle’s frame width.
1. Loosen the nuts holding the clamps on the back of the frame brackets.
2.
Adjust the distance of the slide profiles from each other to the width of the chassis and centre the frame
so the distance from the brackets to the centre of the frame is equally long on both the left and right-
hand sides. Measure the distance between the brackets and the 1st boom’s attachment.
3. Tighten the nuts alternately until the clamp bears fully on the frame.
4. Tighten the nuts.
Tightening torque: 260 Nm.
IMPORTANT!
The frame brackets must be mounted completely parallel with each other and perpendicular to the
support frame.
X mm.
X + 1.0 mm.
Picture 23. Adjusting the chassis bracket
