Z 2500-130/150
Connection unit
61
www.zepro.com
13
Connection unit
13.1
Power save mode
If the control card is not used for approx. 5 minutes, it goes into power save mode. Press any control button for
approx. 0.5 seconds to “wake up” the control card again.
13.2
Operating information
All the lift’s functions are controlled and monitored through the control card, which is equipped with an alphanu-
merical display with a flashing light and 2 red LEDS. These display current operating information. In the event
of any operational disturbances, fault codes are displayed to facilitate troubleshooting.
The display indicates:
-
Active control device
-
Fault display
-
Program configuration
-
Sensors’ current status
The flashing light indicates:
-
Supply voltage
-
Off: No supply voltage
-
On: Supply voltage available but CS (cabin switch) is not active.
-
Flashing: CS (cabin switch) is active, the system is awaiting input signal.
LED 1 indicates:
-
Active input, button(s) on control device pressed.
LED 2 indicates:
-
Active output (approved input signal from control device and sensors), the lift is operated.
Image 79. The control card is equipped with an alphanumerical display with a flashing light and 2 red LEDS
Display
Flashing light
LED 2
LED 1
Summary of Contents for Z 2500-130 Series
Page 2: ......
Page 77: ...Z 2500 130 150 Specifications 77 www zepro com Image 92 Loading diagram 18 4 Loading diagram ...
Page 79: ......
