Zepro Z 2500-130 Series, Installation Instructions Manual

Page: 16 / 80

Z 2500-130/150
16
Installation
www.zepro.com
6 Installation
Also consult the vehicle manufacturer’s body in-
structions and Zepro’s instruction booklet before
installation.
NOTE.
Zepro tail lifts are only approved for installation
with Zepro installation kits.
m
WARNING!
6.1 Support frame
1. Measure and mark the midpoint of the rear beam of the
vehicle. See Image 11.
2. Bolt or spot-weld the mounting jig to the rear beam,
so that both mid-points are aligned. See Image 12.
3. Position the support frame under the vehicle chassis.
4. Temporarily connect the control card to enable the
lift functions, see section "7 Temporary operation
of lift" on page 37.
5. Raise the lift arms to the highest position.
6. Attach the lift arms to the eye of the jig. Use the
steel platform’s normal bolts.
7. The support frame should be positioned as high as
possible within the specified C dimension. Adjust
the frame to the ideal height under the chassis. A
car jack is useful. The frame must be positioned
parallel with the floor of the vehicle body and must
not be in contact with the vehicle chassis; there
must be a few millimetres of play. If necessary
adjust the angle of the arms by carefully operat-
ing the lift.
8. Install the brackets on the support frame so that its
opening is facing towards the front of the vehicle,
and adjust the position of the frame so they are in
contact with the vehicle chassis.
Image 11. Measure and mark the midpoint of
the rear beam of the vehicle.
Image 12. Bolt or spot-weld the
mounting jig to the rear beam
Art. nr. 57370TL for Z 2500
Image 13. Mounting jig,
Image 14. Install the U-profile with as-
sociated washers and nuts