Zephyr HORIZON DHZ-M90AMWX, Installation Instructions Manual

Page: 23 / 60

Optional Remote Control
SYNCHRONIZATION:
To synchronize the remote control with the range hood for the first time, proceed as follows:
1. With the range hood off, press and hold the “Power” on the hood for 4 seconds (Fig.1) until the
“3rd speed” indicator on the hood flashes for 3 times.
2. Press any button on the remote control within 4 seconds to confirm the link (Fig.2). If successful,
the lights of the hood will turn on. The range hood is now syncrhonized with the remote control.
If you experience anyproblems, repeat the procedure.
FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or
peripheral device. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. (1) This device
may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause
undesired operation.
GENERAL INFORMATION:
- Remove any protective film from the remote surface prior to using it.
- The remote control has a range of approximately 10-15 feet.
- The remote control is equipped with a magnetic base and may be attached to ferrous surface
for easy storage.
- The remote top is made of a plastic material and is prone to scratches.
Use care when handling and cleaning the remote; we suggest using a microfiber cloth toclean it.
- The remote control will enter a sleep mode after 20 seconds of inactivity to conserve batterylife.
Press any button for one second to wake the remote.
BATTERY REPLACEMENT:
The batteries will last approximately 8 months, depending on usage.
1. Remove rubber cover from bottom (Fig.3).
2. Using an object such as a screwdriver or pen, gently place it in the center opening in the bottom
of the remote and push inwards to dislodge the top touch panel from the remote body. (Fig. 4)
3. Press on the metal spring located in the battery tray to dislodge battery. Replace both batteries
with type 3V CR2450 (Fig.5). Re-assemble by following instructions in reverse.
3 5 4
- 23 -