Zennio KNX-IP Router / Interface PLess
http://www.zennio.com
Technical Support:
http://support.zennio.com
30
➢
Transmit All (not recommended)
: no telegram filtering or dropping.
➢
Block
: all telegrams will be dropped.
➢
Filter
: telegrams will be filtered, dropping only the corresponding ones,
according to the filter table; see section 2.3).
Group Addresses Telegrams > 13
[
Transmit All (not recommended) / Block
/
Filter
]:
sets the desired action to perform over telegrams destined to group
addresses
beginning with “14” or greater (e.g., 14/1/1).
Physical Addresses Telegrams
[
Transmit All (not recommended) / Block /
Filter
]: sets the behaviour of the device regarding telegrams destined to
individual addresses.
Note
:
transmitting all telegrams (no telegram filtering or dropping) is intended for
diagnostic purposes and may cause risks or conflicts or generate a large amount of
traffic in the KNX installation if permanently activated
.
However, being able to perform
downloads to devices in a different line than the programmer requires setting this
option to “Transmit All”.
3.5
LINE
Note
:
this functionality does not apply to Zennio KNX-IP Interface PLess
.
This screen permits parameterising the behaviour of Zennio KNX-IP Router PLess
regarding the telegrams received from the KNX line.
As shown in Figure 22, the available parameters are completely analogous to those in
the “Main line” tab. Please refer to section 3.4 for a detailed description of these
parameters
