Zennio KNX-IP Router / Interface PLess
http://www.zennio.com
Technical Support:
http://support.zennio.com
19
2.6.2
KNX
Under the “KNX” tag, it is possible to obtain information about the KNX (TP) line and to
perform some actions (e.g.: activate the programming led).
Figure 9
Web interface (KNX line info)
Program Mode: shows whether the programming mode (and therefore the
programming LED) is on or off.
Change Program Mode: activates or deactivates the programming mode, and
therefore the programming LED.
Individual Address: shows the individual address of the device.
Tunneling Addresses. shows the additional individual addresses for the
tunneling function (see section 2.6.2.1).
Set Tunneling Addresses: allows defining additional individual addresses for
the tunneling function (see section 2.6.2.1).
Routing Multicast Address (only in
Zennio KNX-IP Router PLess
): shows
the IP address the KNX telegrams are sent to or received from in the LAN
network. It can be configured in ETS.
Serial number: shows the internal serial number of the device.
KNX Busload (only in
Zennio KNX-IP Router PLess
): shows a graph that
reflects the KNX bus load in the past 60 minutes; see Figure 10. The red
curve represents the local maximum while the green one indicates the local
average load on the KNX bus.
Note
:
this function requires a web browser that supports the SVG (Scalable
