Z35
http://www.zennio.com
Tecnical Support:
http://support.zennio.com
13
The following parameters are shown:
Inputs
[
disabled
/enabled
]
1
: enables or
disables the “Inputs” tab in the tree on the
left, depending on whether the device will or will not be connected any external
accessories. For more information, see section 3.5.
Thermostats
[
disabled
/enabled
]:
enables or disables the “Thermostat” tab in the
tree on the left. For more information, see section 3.6.
Heartbeat (Periodic Alive Notification)
[
disabled
/enabled
]: incorporates a one-
bit object to the project (“
[He
artbeat] Object to Send ‘1’
”) that will be sent
periodically with value “1” to notify that the device is still working (
still alive
).
Figure 3.
Heartbeat.
Note:
the first sending after download or bus failure takes place with a delay of
up to 255 seconds, to prevent bus overload. The following sendings march the
period set.
Home Button Enabled
[
disabled/
enabled
]: enables or disables the home button
to access to the menu page.
Show Time
[
disabled/
enabled
]: permits setting whether the current time
(according to the internal clock) is displayed in the upper-left corner of any page
or not.
Show Temperature
[
No /
Internal Temperature Probe
/ External Value
]: sets
whether the current temperature should show or not in the upper right corner of
every page, being necessary in such case to choose the source of the
temperature value: “Internal temperature probe” or “External value”. If the latter
is chosen, an object named
“
[General]
External temperature
” will be enabled,
so that it can be grouped with any other object that sends temperature values.
1
The default values of each parameter will be highlighted in blue in this document, as follows:
[
default
/rest of options
].