Zennio KLIC-MITT v2, Manual

Page: 26 / 38

KLIC-MITT v2
http://www.zennio.com Technical Support: http://support.zennio.com
26

Auto : if the automatic flap position control is available,

1 / 2 / 3 / 4 / 5 : or any of the available flap positions.

Setpoint [ disabled /enabled ]:

Value:
o
No Change : the last setpoint temperature value will kept. Only
available if Setpoint parameter remains disabled.
o
16…
25
…31
ºC : concrete value of the set temperature.
2.2.6 ERROR HANDLING
KLIC-MITT v2 is capable of managing two error types that do not entail any previous
parameter configuration:
Communication (or internal) errors : errors in the communication process
between KLIC-MITT v2 and the A/C unit. These types of errors are notified by
the green LED as indicated below:

Communication error : KLIC-MITT v2 is not able to establish
communication with the A/C machine. The green LED remains on.

No response (time out) : KLIC-MITT v2 received no response after
sending a request to the A/C unit. The green LED blinks twice and stays
off during 3 seconds.

Wrong acknowledgement : KLIC-MITT v2 received an unexpected
response after sending a request to the A/C unit. The green LED blinks
three times and stays off during 3 seconds.
In case any of the above errors is detected, the corresponding object will be
sent periodically (with a value of “1”) to the KNX bus. Once the error is over, it
the object will be sent (once) with a value of “0”. The object associated with
each error will be, respectively:
 “
[AC] Internal Error: Communication
” (1-Bit).