KLIC-MITT v2
Technical Support:
13
Setpoint limits can be configured by parameter:
Setpoint Limits
[
disabled
/enabled
]:
allows restricting the range of the
temperature setpoint (from below in the Cooling, Dry and Auto modes and
from above in the Heating and Auto modes), provided that the limits are still
within the predefined limits of the A/C unit. When KLIC-MITT v2 receives an
order to send the A/C unit a setpoint which is greater or lower than the
configured limits, it will actually send the limit value.
Minimum (Cooling / Dry / Auto Mode)
[
16
…31
][
ºC
]: sets the upper limit.
Maximum (Heating / Auto Mode)
[
16…
31
][
ºC
]: sets the lower limit.
Figure 7.
AC Gateway. Configuration. Temperature setpoint.
Note
:
if the maximum limit is lower than or equal to the minimum limit, the
limits will not be taken into account under the Auto mode
.
Once these limits are enabled, several objects to modify them at run time will be
available. The values of this objects will be restricted to an interval which is defined by
the absolute limits established by the A/C unit (16ºC to 31ºC).
“[AC] Temperature Setpoint: Lower Limit”
: 2-Byte object that allows
changing the lower limit at run time.
“[AC] Temperature Setpoint: Lower Limit (Status)”
: 2-Byte object with the
lower limit current value.
“[AC] Temperature Setpoint: Upper Limit”
: 2-Byte object that allows
changing the upper limit at run time.
“[AC] Temperature Setpoint: Upper Limit (Status)”
: 2-Byte object with the
upper limit current value.
