Page 57
LT2002 QuickSet Programmer
Cloning Preparations
Before You Begin Cloning...
• Do not use clone with any PPV
card installed in TV or damage to
clone will occur.
• Use MPI port for connecting to MPI
equipment.
• Do not run Auto Prg. (Program) while
TV is connected to clone programmer.
• The “Master TV” should be connected
to a good, stable signal from an over-
the-air antenna or cable service and
turned On.
• Teaching and Learning is only possi-
ble between identical model Zenith TVs.
(However, the Clone programmer can
store 3 different master TV setups.)
WARNING: Copying a blank or incorrect
memory into a TV will cause
the TV to operate erratically or
become inoperable.
• Use an Zenith MBR remote like the
MBR3447 or the TV front panel controls
to operate Learning and Teaching
menus.
• Make sure that the batteries in the
Clone programmer are fresh.
• If the batteries are removed, the
Clone Clock time will be lost.
• Decide if you want to set the time
from the Clone programmer or copy the
time to the Clone programmer; from a
TV which has the clock set to the cur-
rent time.
• Follow the connection diagrams on
the previous page to connect the Clone
to a master TV and, after learning is
complete, to another identical TV to
“teach” it the master setup.
• Setting the time and transferring it
to the Clone or another TV is a separate
procedure.
• Once a TV’s setup is copied to anoth-
er TV, that TV needs to be disconnected
from power for about 5 seconds to acti-
vate the newly copied setup.
• See Troubleshooting to solve prob-
lems.
A. Set Up a Master TV
Using an Zenith Multi-Brand remote like
the MBR3447, set up a “Master” TV
with custom settings and features as
described in the TV’s operating guide.
The master TV’s Setup is what you will
copy to the Clone Programmer and
transfer to TVs with the same model
number so they will operate identically.
B. Connect Clone to Master TV
If there is a good connection, the
“Clone has Control of the TV” message
will appear. (See menu on the previous
page.)
A slow flashing green light indicates there is a problem with the communica-
tions between the TV and the programmer. In this case, check for a damaged
cable, poor contacts or other connection troubles.
If the status indicator is red, the programmer batteries are low and should
be replaced. Use 4 good-quality alkaline AA batteries.