Zenith FFH-185A, Installation And Operating Manual

Page: 13 / 14

13
SLEEP FUNCTION
AMP
Output Power(6Ω, 2ch,T.H.D 10%):
20W+20W
Frequency Response: 42~25,000Hz
FM
Tuning Range:
87.5~108 MHz
S/N Ratio(98.1 MHz)
64/55dB(Mono/Stereo)
AM(MW)
Tuning Range:
530-1720kHz
Usable Sensitivity: 55dB
DECK
S/N Ratio: 43dB
Channel Separation: 50dB
CD
Frequency Response: 40~18,000Hz
S/N Ratio: 70dB
T.H.D: 0.2% Dimensions(WxHxD):180x248x241mm
Weight(net): 4.7 kg
Power Requirements:
Refer to the back panel of the unit.
Speaker System
Impedance: 6Ω
Rated Input Power: 20W
Max Input Power: 40W
Frequency Response: 70~18,000 Hz
Dimensions(net):
160(W)x248(H)x175(D)mm
Weight(net): 2.02 kg
NOTE:
Designs and specifications are subject to
change without notice for improvement.
When the sleep timer is used, the power is
automatically turned off after the specified
time has elapsed.
1. To select the time to turn off:
Press the “ SLEEP ” button. (remote
control only)In the display. you can see
for about 5 seconds. This
means that the system turns off
automatically after 90 minutes.
Each time the button is pressed the time
interval before it tums off is reduced by
10 minutes. i.e. 80...70... etc.
Select the desired time to turns off.
2. To check the time to turn off:
While the sleep function is active press
the “
SLEEP ” button briefly. The time
remaining until it turns off is displayed for
about 5 seconds.
NOTE:
If you press the “ SLEEP ” button while the
sleep time is displayed, the SLEEP time is
reset.
3. To turn off the sleep function:
If you wish to stop the function press the
“
SLEEP ” button repeatedly until 10
appears, and then press the “ SLEEP ”
button once again while 10 is displayed.
SPECIFICATION