ZENA mobile welding system -- Operators Manual -- Series 150 & 200 Welders
28
28
screw, lubricate the o-ring with some mineral oil. Failure to properly lubricate
the o-ring before reassembly may result in permanent damage to the o-ring.)
If a o-ring leak is not the problem, or if the o-ring seal cannot be reestablished,
the actuator will require replacement. Go on to the next step.
7.5
You have a problem which requires the assistance of our tech support
department (877-ZENA INC or 615-897-2011).
C. Optional Power Control Interface Module (PCIM)
C. Mechanical
Problems
Symptom
Likely Problem
V-belt squealing
Belt loose OR worn out
V-belt and/or pulley attached to the
Welding Power Generator gets very
hot
Belt mis-aligned OR too tight OR too
loose
Mechanical noise is heard
continuously
Mounting bracket loose or mis-aligned
Mechanical noise is heard only when
welding
Mounting bracket loose or mis-aligned
or defective Welding Power Generator
When the engine is running, excessive
vibration is felt at (or in) the Welding
Power Generator.
Mounting bracket loose or mis-aligned
Excessive vibration is felt at Welding
Power Generator ONLY when welding
power is being generated
Mounting bracket loose or mis-aligned
or defective Welding Power Generator
