Zelmer 17Z019, User Manual

Page: 20 / 22

22
4 Close the lid.
5 Place the kettle on the power base (4) .
6
Put the plug of the connecting cord into a mains socket
with an earth pin.
7 Switch the kettle on by pressing button (6) – the light will
come on.
8
The kettle switches off automatically when the water has
reached the boiling point, the switch returns to its starting
position – the light comes off.
If further use of the kettle is anticipated, it is not necessary
to remove the plug of the connecting cord from the power
socket.
WARNING: Be careful not to fill up with water beyond
the nominal capacity when pouring water into the
kettle.
The rising of the water level in the kettle is delayed in relation
to the speed of pouring the water. It is caused by the filter
slowing down the speed of the flow. This can be prevented
by pouring the last portions of water extremely carefully
before it reaches the maximum level on the indicator.
In the event that an empty kettle is switched on, it will be
switched off by a thermal device automatically.
In order to switch the kettle on again after it has cooled
down (approx. 15 minutes), take it off the base, replace it
and switch the kettle on by pressing switch (6) . The cooling
down of the kettle can be accelerated by puring cold water
into the kettle.
Cleaning and maintenance
Always clean a cold kettle!
1 Remove the plug of the connecting cord from the power
socket.
2 Take out the filter (8) .
3 Clean the outside surfaces with a soft cloth moistened
with washing-up liquid.
In order to remove the build-up of hard water film from the
outside and inside walls of the kettle, wipe them with a cloth
moistened with vineger.
4
Rinse the kettle with fresh water.
Filter replacement – descaling
In the event that scale builds up on the bottom of the kettle,
it needs to be removed. 6% or 10% vinegar is used for this
purpose.
Open the lid
●
(5) .
Take out the filter
●
(8) .
Wash the filter under running water.
●
Pour 0.5 l of vinegar and switch on the kettle.
●
Boil the vinegar and leave in the kettle for about 30
●
minutes.
Pour the vinegar out and rinse the kettle with fresh water.
●
Fill the kettle up with fresh water, boil the water and pour
●
it out after is has boiled.
Repeat the above procedure if there still is scale on the
●
bottom.
When the procedure is finished, replace the fiter
●
(8) in
the kettle, following the procedure of taking the filter out
in reverse order.
Negligence in descaling the kettle may results in its
damage.
Ecology – environment protection
Each user can protect the natural environment. It is neither
difficult nor expensive.
In order to do it: put the cardboard packing into
recycling paper container; put the polyethylene
(PE) bags into container for plastic.
When worn out, dispose the appliance to
particular disposal centre, because of the
dangerous elements of this appliance, which
can be hazardous for natural environment.
Do not dispose into the domestic waste disposal!!!
The manufacturer/importer does not accept any liability for any
damages resulting from unintended use or improper handling.
The manufacturer/importer reserves his rights to modify the product
any time in order to adjust it to law regulations, norms, directives,
or due to construction, trade, aesthetic or other reasons, without
notifying in advance.