SET-UP
Mechanical stage S mot. CAN
Carl Zeiss
Mounting the mechanical / …
Measuring stage S mot. CAN
16
435465-9000-701
08/2012
3.2.2
Mounting the mechanical /
measuring stage S mot. CAN on
stand base 450 for epi-illumination
•
If necessary, remove the metal plate (Fig. 5/
1
)
from insert plate (Fig. 5/
3
) by pressing and
tilting the rear edge.
If stand base 450 (Fig. 5/
5
) is not provided with an
adapter ring (Fig. 5/
4
) this must be mounted first:
−
Remove the insert plate (Fig. 5/
3
). To do this,
remove the three screws (Fig. 5/
2
) and keep
them for possible later use.
−
Insert the adapter ring (Fig. 5/
4
) into the
stand base 450 and secure with the three
captive screws (Fig. 5/
6
).
−
Detach the insert plate (Fig. 5/
3
) from the
stand base 450 (Fig. 5/
5
).
•
Set the mechanical / measuring stage (Fig. 6/
3
)
on the insert plate (Fig. 6/
1
) (stage drive
pointing to the left), align to the rear edge and
secure with the three captive screws (Fig. 6/
2
) of
the stage on the transillumination top.
•
Insert the metal plate (Fig. 6/
4
) into the stage.
The procedure for inserting the plate
into and removing from the stage is
described on page 15.
The red dots on the stage (Fig. 6/
3
)
and metal plate (Fig. 6/
4
) are to ensure
reproducibility of the alignment of the
metal plate and stage if the former
needs to be detached.
Fig. 5
Mounting the adapter ring
Fig. 6
Mounting the
mechanical /
measuring stage mot.
on
stand base 450
