Mechanical stage S mot. CAN
SET-UP
Measuring stage S mot. CAN
Mounting the mechanical / …
Carl Zeiss
08/2012
435465-9000-701
15
3.2.1
Mounting the
mechanical /
measuring stage S mot. CAN
on
base 300 for epi-illumination
•
If necessary, remove the metal plate (Fig. 3/
1
)
from base 300 (Fig. 3/
2
) by pressing and tilting
the rear edge.
•
Set the mechanical / measuring stage (Fig. 3/
4
)
on the base 300 (stage drive pointing to the
left), align it to base 300 secure with the three
captive screws (Fig. 3/
3
) of the stage.
•
Insert the metal plate (Fig. 3/
5
) into the stage.
−
To do this, push the plate (Fig. 4/
3
) into the
stage (Fig. 4/
1
) with the left front corner
slightly inclined allow it to slide under slight
pressure against the springs (Fig. 4/
4
) until it
is completely inside the stage interface. The
plate is held in the stage by spring pressure.
Take care to ensure that the plate is correctly
positioned on the stage.
−
To remove, insert a screwdriver into the
recess (Fig. 4/
2
) and carefully prise the plate
out.
The red dots on the stage (Fig. 3/
4
)
and metal plate (Fig. 3/
5
) are to ensure
reproducibility of the alignment of the
metal plate and stage if the former
needs to be detached.
Fig. 4
Inserting the metal plate (glass plate) into or removing it from the stage
Fig. 3
Mounting the
mechanical /
measuring stage mot.
on base 300
