INTRODUCTION
Carl Zeiss
Notes regarding operational safety
Auto Focus equipment
8
425131-7044-001
06/2013
The following notes should be strictly observed:
Class 3B IR radiation, invisible LED radiation while the sensor module is open. Do not expose eyes
to IR radiation.
The Auto Focus sensor module does not include any special facilities providing protection from
samples with a corrosive, potentially infectious, toxic, radioactive or other health-damaging
effect. You are under obligation to comply with all legal requirements, in particular national
accident prevention regulations, when handling samples of this kind.
Dirt or dust may adversely impact the device’s operating capability. For this reason, steps must be
taken to eliminate such influences as much as possible.
The device may not be opened except by trained personnel or service technicians. The
Auto Focus may not be operated in an explosive atmosphere.
Always pull the main power plug before removing the device or replacing a fuse! Refer to
section 5.2 on page 32.
Only fuses of a type specified in the technical data section may be used. The use of makeshift
fuses and shorting of fuse holders is prohibited.
The manufacturer cannot accept liability if the device, or individual assemblies or parts thereof,
have been used for any other purpose. The same will apply if service or repair work of any kind
is not performed by authorized service personnel. In this case all rights to claim
warranty / guarantee will be null and void.
The main power plug may only be inserted into a socket with PE contact, and its built-in
protection must not be rendered ineffective by using a cable extension without a PE conductor.
Should it be determined that protective measures are no longer effective, shut off the power to
the device and take precautions to ensure that it cannot be inadvertently switched on again.
Contact the Zeiss Customer Service or Carl Zeiss Microscopy Service to have the device repaired.
Clogged or covered ventilation slots may result in heat build-up with a damaging effect on the
device. Always keep the ventilation slots unobstructed and refrain from inserting or dropping
objects into a ventilation slot.
A defective controller does not classify as domestic waste. It must be disposed of in accordance
with currently valid provisions of law.
Likewise, samples must be disposed of in accordance with currently valid provisions of law and
internal work instructions.
Summary of Contents for Auto Focus
Page 1: ...Operating Manual Auto Focus equipment...
Page 2: ......
