Zeiss Auto Focus, Operating Manual

Page: 34 / 38

MAINTENANCE, REPLACEMENT OF FUSES AND SERVICE
Carl Zeiss Error messages and typical background … Auto Focus equipment
34 425131-7044-001 06/2013
5.4 Error messages and typical background situations
Error message Meaning Possible cause Measure
"Invalid
Objective" No valid objective is
currently in position.
−
Empty objective turret position.
−
No approved objective
configured for the Auto Focus.
−
Check configuration
"timeout" The Auto Focus could
not find the focal plane.
−
The distance between the
object and the focal plane is too
great (timeout).
−
Problematic object structure.
−
Check the positioning of the
object.
−
Beam splitter of the camera
deflection not swiveled into
position.
"Err: busy
0x0D" Due to an error, the
Auto Focus is not ready
to function
−
An unsuitable objective has
been attempted for use with
Auto Focus. This error may
occur after reconfiguration
when using the Auto Focus
again for the first time.
−
Cable connection interrupted.
−
Reactivate the Auto Focus.
−
If the cable connection was
interrupted. Shut down the
Auto Focus and the
microscope, reconnect the
cables and restart the Auto
Focus and the microscope.
"Err: camera
0x64" The Auto Focus sensor
cannot operate. −
Cable connection interrupted.
−
Shut down the Auto Focus
and the microscope,
reconnect the cables and
restart the Auto Focus and
the microscope.
"Err: external
device 0x10"
The Auto Focus sensor
cannot operate.
−
Cable connection interrupted.
−
Shut down the Auto Focus
and the microscope,
reconnect the cables and
restart the Auto Focus and
the microscope.
"Detecting
Stand" The Auto Focus is
searching for the
connection to the stand.
−
The components are in the start
process.
−
No connection to stand.
−
Shut down the Auto Focus
and the microscope, connect
the CAN cable to the
microscope stand and restart
the Auto Focus and the
microscope.
Table 4 Error messages, typical background situations and possible remedial action