Zeiss 15501-0101-000, Instruction Manual

Page: 18 / 282

5 First Operating Steps | 5.1 Prerequisites for Commissioning and Operation ZEISS
5 First Operating Steps
This chapter describes the switching on/off as well as the first operating steps with the Micro-
scope.
Info
Additional information and detailed descriptions are available in the further applicable docu-
ments, or ask your ZEISS Sales & Service Partner.
Info
Further information on the software and its operation is available in the software’s online help.
5.1 Prerequisites for Commissioning and Operation
The following basic prerequisites are necessary for commissioning and operation:
§ The Instruction Manual was read prior to commissioning or operation and kept for further
use.
§ Chapter Safety is read and understood.
§ Operator is acquainted with the general Windows ® -based programs.
§ If required: Basic training and safety briefing successfully completed.
5.2 Switching On the Microscope
Prerequisite
ü
The microscope is connected to the mains [
}
17] .
Procedure 1. Turn the light intensity knob.
2. Adjust the illumination to the desired intensity.
à The selected intensity is indicated by the light-emitting diodes on the stand.
5.3 Adjusting the Position of the Eyepieces
Info
The adjustment of the interpupillary distance is correct when you see only one round image
while looking through the two eyepieces.
Procedure 1. Set the interpupillary distance by rotating the
eyepiece tubes symmetrically toward or away
from one another.
18 Instruction Manual ZEISS Primostar 1 | en-US | Rev. 2 | 415501-7021-111