29
2. Press the sensor system module into the recess of the EPP housing, bearing in mind the cable routing.
3. Put the upper EPP housing section on the lower EPP housing. Install the sensor cable at the rear and side in the designated
cable recess on the EPP housing sections to that the cable ends in the vicinity of the control board.
4. Connect the cable to the terminal point SENSOR X8 on the control board.
Ensure that the sensor wires are connected correctly to the sensor X8 terminals per the table below.
Color coding
for sensor
cable
Terminal
point for
SENSOR X8
Signal
brown
1
Positive (+)
white
2
Negative (-)
green
3
CL
yellow
4
DA
5. The four-pin DIP switch MODE SW1 is used for the configuration of the Automatic function for the sensor system module. If
necessary, correct the positions of the DIP switches in accordance with designated functional principle of the Automatic mode
(see page 30, 4.2.6).
Fig. position of DIP switches, factory setting
