Technical Note “Complete Guide to Monitoring the Azzurro ZCS Systems via Wi-Fi”
-
Rev. 1.2 of 20/05/2019
Zucchetti Centro Sistemi S.p.A. - Green Innovation Division
Via Lungarno, 248 - 52028 Terranuova Bracciolini - Arezzo, Italy
www.zcsazzurro.com
Page
6
of
38
Figure 5 – Correctly installed Wi-Fi card
7)
Reconnect the flat cable in its seat and close the two plastic hooks, making sure that they close
properly. Place the front cover in its original position and secure it by rescrewing the four Allen screws
that were previously removed.
8)
Start the inverter in the regular way as described in the manual, supplying first DC voltage and then
AC voltage via the wall-mounted switches.
2.2 PROCEDURE FOR CONFIGURING AN INTERNAL WI-FI CARD
Go to front of the inverter and search for the Wi-Fi network using a smartphone or computer, to make sure
that the signal from the home Wi-Fi network reaches the place where the inverter is installed.
If the Wi-Fi signal is present in the location where the inverter is installed, you can start the configuration
procedure.
If the Wi-Fi signal does not reach the inverter, it is necessary to install a system that amplifies the signal and
brings it to the place of installation.
1)
Search for any wireless networks in order to display the network of the inverter’s Wi-Fi card, which is:
AP_0805925180
.
The number indicates the serial number of the Wi-Fi card, which can be checked by referring to the
smaller label located at the lower left side of the inverter.
2)
Open the browser and enter the following IP address in the search bar to access the web server inside the
Wi-Fi card:
10.10.100.254
3)
For both the username and password, enter:
admin
