Zaxis Isaac HD, User Manual

Page: 7 / 75

7
Rear Panel
1.
Foot Switch Connector : For starting a test. Any closed contact switch may be used to start a test by
shorting pins 1 & 3
Mating Conn. & Pins – Tyco Electronics 1-480305-0 ( Digi-Key A1400-ND ), 60618-1 ( Digi-Key A1422-ND )
2.
Serial Output : Connection for interfacing Isaac to computers or printers. ( Wiring )
3.
Option Space : This space is used for Clamping (pneumatic outputs) or I/O connection
(shown) ((Wiring))
If the I/O space is filled clamps will be in the secondary air connection location.
4.
Pressure Regulator : Controls the air pressure applied to the product under test.
5.
Power Entry Module : This component includes the power cord socket, on/off switch, and the fuse
holder. Power entry is capable of a range of 109-255~VAC. 2A Fuse ( Service instructions )
6.
Secondary Air Connections : These positions have multiple uses; Flow control for ramping burst/crack
pressure, coupling or pilot air entry, or secondary test air supply. See the Quick Start shipped with the
tester for details.
7.
Supply : (Air or other test gas) Connection is 1/8 ” -27 F NPT (Similar to R1/8 BSPT British Standard Pipe
Thread) Supply gas must be clean and dry.
8.
Ethernet Connector : ASCII communication, data output and command string input.
Additional items may be installed on the rear panel, see the quick start guide
shipped with the tester for additional details.
1
2
3
4
5
6
6
7
8