AUTOMATIC GATE OPENER
• Installation Manual
20
Step 17
(fig. 28)
Connect the color-coded gate opener (actuator) wires
to the terminal block located on the bottom of the con-
trol board marked Opener 1 (SINGLE). Do this by insert-
ing the wires into the terminal block and tightening the
set screw in the terminal block.
1. Connect the RED gate opener (actuator) wire to the
OPENER 1 (SINGLE) RED terminal.
2. Connect the BLACK
gate opener (actua-
tor) wire to the
OPENER 1 (SINGLE)
BLK terminal.
3. Connect the BROWN
gate opener (actua-
tor) wire to the
OPENER 1 (SINGLE)
BWN terminal.
4. Connect the BLUE
gate opener (actua-
tor) wire to the
OPENER 1 (SINGLE)
BLU terminal.
ON/OFF switch
Figure 25
Battery wires
Battery (included)
Space for optional second battery
Strain relief
Gate opener
cable
Figure 28
Figure 26
BLACK (-) terminal
RED (-) terminal
Connect the Gate Openers (Actuators) to
the Control Box
CAUTION!
Ensure that the control box power switch is
in the OFF position before connecting the control box.
Step 16
(fig. 27)
Insert the first gate opener (actuator) cable through the
front strain relief housing and into the control box by
loosening the strain relief sealing nut located on the
outside bottom of the control box and feeding the gate
opener (actuator) cable into the control box.
NOTE:
The gate opener with the 10’ cord (mounted
closest to the control box) will be referred to as
“Opener 1.” The gate opener with the 40’ cord will be
referred to as “Opener 2.”
Strain relief housing
Gate opener cable
Figure 27
