AUTOMATIC GATE OPENER
• Installation Manual
32
4. Follow the instructions for setting the CLOSED limit.
If the gate continues to stop without reaching the
fully opened position proceed to
step 5
.
5. Open the control box cover, and:
a) Observe if the green “STATUS” LED light is blinking
once per second.
b) Verify if the red or green battery charging indica-
tors are on.
c) Verify the wires connected to VAC, Solar (if applica-
ble), Opener 1, Opener 2 (if applicable), Cycle,
Safety Sensor, Exit, Vehicle Loop, Closed/Open
Edge, and Receiver terminals (red, black, grey) are
not loose.
d) If steps a – c did not solve the problem, please call
customer service.
The gate will not open using the handheld
transmitter.
1. Remove the cover from the transmitter.
2. Remove the RF receiver box cover. Verify the DIP
switch settings on the transmitter are the same as
those in the receiver.
3. If steps 1– 2 do not reveal an existing problem,
please contact customer service for further assis-
tance.
The gate will not open or close.
1. If applicable, ensure the 18 VAC transformer is still
plugged into the 110 VAC source.
2. Open the control box cover, and:
a) Observe if the green “STATUS” LED light is blinking
once per second.
b) Verify if the red or green battery charging indica-
tors are on.
c) Verify the wires connected to VAC, Solar (if applica-
ble), Opener 1, Opener 2 (if applicable), Cycle,
Safety Sensor, Exit, Vehicle Loop, Closed/Open
Edge, and Receiver terminals (red, black, grey) are
not loose.
3. Verify the 15 amp fuse is not blown.
If steps 1– 3 do not reveal an existing problem, please
contact customer service.
When my gates close, they do not align with
each other.
1. Clear your closed limit settings. Return the gates to
the fully open position. Press and hold the SET LIMIT
button for five seconds until the green LED turns off.
The closed limit setting is now erased.
2. Repeat steps 1 – 8 from the section of the manual
titled “Setting the Gate’s Closed Limit Position”
3. Verify gates close and are aligned properly.
If steps 1 – 3 do not resolve the problem, please con-
tact customer service.
Customer Service
8:00am to 5:00pm, Central time, Monday – Friday
Zareba Systems
906 Fifth Avenue E
Ellendale, MN 56026-2193
Phone: 800-272-9877 or 507-684-3721
Fax: 507-684-3722; Email: [email protected]
