G550 Automatic Gate Opener
Installation Manual
16
Overview
This section begins with installation instructions for
gates that open
into
the property or “pull-to-open”
gates.
NOTE:
Gate opener is mounted inside the gate/prop-
erty. A pull-to-open gate will open toward you if you are
standing inside the gated property and facing towards
the gate.
To mount the opener on a brick, masonry, or rock col-
umn, refer to
page 28
.
If you have a push-to-open gate, you must use a push-
to-open bracket (sold separately). See
Push-to-Open
Installation on page 26
.
For any installation, having another person assist the
installer is helpful.
Bracket Mounting
(fig. 10)
The proper position of the mounting brackets is crucial
to the efficiency and leverage of the gate opener. The
distance between the gate opener (actuator) and the
gate is also determined by the proper position of the
mounting brackets.
NOTE:
Ensure a minimum 2” space exists between the
gate and the gate opener (actuator) for safety reasons.
The curved design of the post brackets accommodates
either round or square posts. When mounting the post
brackets, use bolts long enough to pass through the
entire post. When mounting the post brackets to wood-
en posts, use a larger-size washer or metal plate (sold
separately) between the bolts and the wood post to
ensure the stability of the fastening hardware when
thrust is applied.
If you are using gate posts smaller than 6” diameter or
square, they should be (1) made of metal, and (2) set in
cement to ensure the stability of the post.
INSTALLATION
Metal plate or
large washer
Wooden post
Pivot bracket
Post bracket
Metal plate or large
washer
Wooden post
Post bracket
Pivot bracket
Figure 10
