65
Replacing the oven light
Disconnect the appliance from its power
supply point. Push in and unscrew the glass
cap (Fig. 9). Unscrew the light bulb and
replace it with a new heat-proof bulb (300
°
C)
having the following features:
- Operative tension: 220/230 V (50 Hz)
- Power: 25 W
- Fitting: E 14
Reconnect the appliance.
Oven door cleansing
For a better cleansing of the oven door, you
are suggested to remove it from the appliance
with the following procedure: open tho door
completely; lift the small levers placed on the
two hinges and turn the levers towarde the
inside (Fig. 15). Slowly close the oven door,
until it touches the two levers, then push it
towards the oven and remove it by pulling it
towards the outeide. Place the door on a
horizontal level, then remove the screws
(Fig16), lift the glass and pull it out. After
cleansing the glass, refit it in the door ( Fig.16)
and assemble the door again by carrying out
the procedure described above backwards.
When the two small levers are placed again
on the hinges, the door will have been
accurately fit.
Cleaning care
The upper element of the oven radiating heat,
can be overturned. In order to make the
cleaning of the interior part of the oven easier,
the upper element radiating heat (upper heat
and grill) should be overturned. Loosen the
knurled screw (Fig. 17) and overturn the
element radiating heat downwards (Fig. 18).
At this point the surface of the oven can be
cleaned (see “General cleaning care”). Put the
element radiating heat back in its place and
tighten the screw you have loosened before.
Always ensure that the element is in the right
place.
