9
Apply a zigzag bead of Zagi-Lock
CA glue to one of the flat surfaces
of the center section. Make sure to
apply a small bead of glue in the
motor mount stick cutout on the
opposite panel. Spread the glue
evenly with scrap paper. Push the
panels together. Align the panels
according to the center bulkhead.
Locate the red Zagi-FiXX decal on
the decal sheet. The decal is used
as a glue clamp for the motor pylon.
Stick it on top of one of the panels.
Match the alignment marks to find
the centerline.
The motor mount stick cutout is the
square slot located on the motor
pylon. Squeeze a bead of Zagi-Lock
the length of the slot.
Slide the motor mount stick into the
slot. Make sure that the stick
bottoms in the slot. Half of the motor
mount stick will remain to be used
as an alignment pin for wing
joining.
