11
The antenna groove is located on the
right panel. It extends from the center
pod all the way to the tip. At the pod
end of the antenna groove, spin a
1/8” drill bit or a pointed tool to
make a hole. Aim the drill at an
angle to come out in the corner of
the receiver bay. Spin the drill
through to the receiver bay.
Pull only enough antenna wire
through the hole to extend to the tip
of the wing. Extend the wire to the tip
along the groove. Hold it in place
with small pieces of Scotch tape six
inches apart.
Clear the antenna hole from the top
side. Push the antenna wire through
the hole from the top to the bottom
side
.
Do not cut the extra antenna wire!
Do not cut the extra antenna wire!
Do not cut the extra antenna wire!
Do not cut the extra antenna wire!
Do not cut the extra antenna wire!
Some radio manufacturers provide a
small fixture to spool the extra
antenna wire. If this is not the case,
locate the popcicle stick in the parts
bag. Cut a 1-1/2 inch piece from the
stick. Check that the stick fits good
and tight across the aft end of the
receiver bay.