Locate the 1 x 10 inch clear vinyl
tape in the decal bag. Peel the clear
backing. Secure one inch of the tape
to the aft end of the skid.
Hold the tape securely and pull it
until it curves to the shape of the
skid. Pull and lower the curved tape
onto the full length of the skid. Press
the tape to the contour of the skid.
The vinyl tape is important to create
an armor film for landing.
Apply a small amount of Zagi-Lock
CA to the opposite motor mount
stick cutout. Match the front align-
ment pin with the groove and pinch
the wing panels together at the skid.
Quickly wipe any glue that squeezes
out with a paper towel. Clamp with
clothes pins or just hold the halves
together a few minutes until the glue
sets.
Apply a bead of Zagi-Lock CA glue
to the flat surfaces above the motor
wire hole. Pinch the seam together
and pull the tape over to the other
side.
10
