ZAGI Zagi-Fixx, Assembly Manual, Page: 2 / 24

Safety Safety
Safety Safety
Safety is important even with these small
motors. Do not run the motor until it is
installed. See page 18.
ZZZZZ-F -F
-F -F
-Foam oam
oam oam
oam is a unique matrix that is
resistant to solvents. The urethane paint
however is not. Repairs can be made
with Zagi-Lock and clear tape. Avoid
overflowing the glue onto the painted
surfaces. Isopropyl alcohol (rubbing
alcohol) or Windex can be used safely to
remove residual mold release before
applying tape or decals. Place the decals
carefully the first time. The decal
adhesive will lift the paint.
NiCad and NiMH NiCad and NiMH
NiCad and NiMH NiCad and NiMH
NiCad and NiMH batteries are not
shipped with a charge. All batteries must
be charged before any hookup can be
done. Charge the TX (transmitter) battery
over night with the charger in the radio
component box. The radio component
charger will not charge the 8 cell 370
mAh NIMH battery. It must be charged
with a separate charger. Make sure that
the charger is designed to charge a 9.6v
8 cell MiMH battery.
Use the decal stars sparingly Use the decal stars sparingly
Use the decal stars sparingly Use the decal stars sparingly
Use the decal stars sparingly..... Since
most decals and other design decora-
tions are applied behind the center of
gravity, the wing can become tailheavy.
The decals are better used for repairs.
(See page 21)
PPPPPusher motors usher motors usher motors usher motors usher motors don’t have the advan-
tage of the prop wash for cooling.
Pushers instead depend on the air
resulting from the forward motion of the
aircraft. A heat sync employs heat
conducting aluminum fins to help the
motor case dissipate heat by increasing
the surface area. Lowering the operating
temperature can extend the life of the
motor. The heat sync was manufactured
to close tolarances and must be installed
correctly to conduct properly.
The Zagi-FiXX kit contains:
Right and left wing panels
1
!
370 mAh NIMH 8 cell 9.6v battery
with connector
1
!
Zagi 5 amp electronic speed control
with BEC
1
!
GWS EPU-3.5:1 motor and gear set
with mount stick and an 8x4.3 prop
1
!
Battery charge lead wire
2
!
Pre-shaped adjustable servo-saver
control rods
2
!
Control horns
1
!
Tube of Zagi-Lock CA adhesive (Ethyl
Cyanoacrylate)
1
!
Custom decal repair set with leading
edge and skid armor kit
1
!
Popsicle stick for antenna spooler
Optional accessories: Available
from Trick R/C
12 mm replacement motor without gear set
Lightweight antenna wire.
Heat sync for 12 mm motor (not included)
3
!
370 mAh NIMH 8 cell 9.6v battery
packs with connectors
6
!
370 mAh NIMH 8 cell 9.6v battery
packs with connectors
Copyright 2002 Trick R/C Products LLC
1