The Zagi-3C Kit Contents:
2
Expanded polypropylene (EPP) wing panels and beds
2
Pre-cut balsa elevons
1
Roll 2.2 mil color poly tape
2
Control horns with 2 screw plates and 4 screws
2
Threaded 2-56 control rods
2
Threaded 2-56 clevises
2
Die-cut clear plastic winglets
1
1 1/2” x 2” x 8” EPP foam block for repair and reinforcement
1
Roll of 2” wide fiber filament tape
Needed Components:
1
Receiver (RX)
2
Standard servos (cutouts are for “standard” servos but minis may be used)
1
Battery A 600 mAh NiCd AA size battery will allow several hours of flying
before recharging.
Tools and Materials Needed:
Small 90 degree square
Sanding block
150 to 320 grit sandpaper
X-acto knife with #11 blade
Dremel (optional)
Spray adhesive (3M Super 77)
Lead weights for balancing (if needed)
Additional roll 2.2 mil color poly tape in contrasting color (optional) - see text
Round pencil or ball point pen
Mixing (popsicle) sticks
Wax paper and/or clear wrap
Scissors
Z-bend pliers (optional)
page 3
