27
DOC-USR-0080-01
____________________________________________________________________________________
Z3 Technology, LLC
♦
100 N. 8th St. STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
7.0
RUNNING DECODE ON THE Z3-MVE-10
This section gives step-by-step instructions on taking the Z3-MVE-10 and using it to decode a stream from
the Ethernet. A source generating this stream (for example, another Z3-MVE-10) is required.
7.11
Connect the Decoder
(1)
Use a BNC-to-BNC cable to connect “ASI/SDI Output” on the Z3-MVE-10 to an SDI monitor or to “SDI
In” of an SDI->HDMI converter:
(2)
Connect the Ethernet to a hub or router connected to the control PC and the streaming source.
(3)
Connect the power to the Z3-MVE-10.
(4)
Power on the Decoder Z3-MVE-10.
7.12
Set up the Decoder to Work with the Encoder
(5)
If you are using another Z3-MVE-10 as the encoding source, you need to make sure that the encoding
Z3-MVE-10 and decoding Z3-MVE-10 have different IP addresses. If you are using DHCP, this will
automatically be taken care of. If you are not using DHCP, you should set at least one of them to
use DHCP to ensure the addresses are different (see Section 6.6 on page 17 for details).
Figure 28 Z3-MVE-10 Connections for Decode
(2) Connect to hub/router
connected to PC and
streaming source
streamer
(1) Connect to SDI Monitor or
“SDI In” of an SDI->HDMI
converter
(3) Connect power
