37
DOC-USR-0080-01
____________________________________________________________________________________
Z3 Technology, LLC
♦
100 N. 8th St. STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
D1 Sharpness
(For Composite Input
Only)
0
-2
Controls the peak and coring filters of the
analog front end for D1. 0 is a normal (flat)
setting. 2 causes the highest sharpness
gain. The encoder will encode more
efficiently with less sharp pictures. If the
bitrate is high, this can be used to enhance
the picture quality. The general
recommendation is to leave this at 0.
Output Interface
Ethernet (VBR)
ASI
ASI+Ethernet (CBR)
Selects where bit stream is output
(Ethernet, ASI, or both).
*
Note:
RTP can only be streamed over
Ethernet.
Output Format
RTP
MPEG-2 TS
MPEG-2 TS RTP
RTMP
Output format of encoded stream.
*Note
: RTP requires an SDP file for the
receiver.
“MPEG-2 TS RTP” sends a stream
encapsulated with MPEG-2 TS within an RTP
transport stream.
See “Streaming RTMP” for details on using
RTMP.
Dest Address
x.y.z.w
(225.1.2.3)
The IP address that the encoder is
streaming to.
Dest Port
0 – 9999 (
8888
)
The port that the encoder is streaming to.
TS Bit Rate
0 – 20Mbps (
12Mbps
)
Only appears for “MPEG-2 TS” and “MPEG-2
TS RTP” Output Formats. The overall bit
rate for the generated transport stream. A
margin of 30-50% over the video bit rate for
high bit rates is recommended.
PID Audio, Video,
PCR
0 – 999 (
120, 220, 520
)
The PIDs assigned to audio, video, and the
PCR in the TS stream. Values are separated
by a space.
Stop Encoder
[Button]
-----
Stop current encode session.
Start Encoder
[Button]
-----
Start encode session.
Status
Idle
, Stopped, Running
Current status of the encoder.
Note 1: Encoder Resolutions Supported:
1080i (1920x1080), 3/4 1080i (1440x1080), XGA (1280x1024), 720p (1280x720), 4/5 720p
(1024x720), D1 NTSC (720x480), D1 PAL (720x576), 4-CIF (704x576), VGA (640x480) 2-CIF (352x576),
CIF (352x288), SIF (352x240), QVGA (320x240), WQVGA (320x180)
