CONFIDENTIAL
DOC-USR-0259-02
9
______________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
connection necessary between the camera and the encoder. The KEL ribbon cable provides the following
connectivity:
▪
Power from the encoder to the camera
▪
Video from the camera to the encoder
▪
Sony VISCA
™
controls, bidirectional, using a serial port
This connector provides a direct connection with the Sony FCB-ER8300 block camera. Make sure to use the
KEL ribbon cable provided or approved by Z3 Technology. Risk of permanent damage to the camera or
encoder exists if a non-approved cable is used.
The connector used is a KEL USL00-30L.
The pin assignments on J5 are shown in the table below.
Please note that the pin numbering of J5 on the Interface Front End PCB is opposite of that on the Sony FCB-
ER8300 camera.
Pin
(J5)
Pin
(4K
Camera)
Signal
Notes
1
30
DC Input
Power from encoder to camera. Power
comes directly from DC input jack or
PoE module, whichever is active.
2
29
3
28
4
27
5
26
RESET
Encoder reset signal to camera
6
25
VISCA_TXD
Serial control, camera to encoder
7
24
VISCA_RXD
Serial control, encoder to camera
8
23
GND
9
22
No connect
4K Camera signal USB_D+
10
21
No connect
4K Camera signal USB_D-
11
20
GND
12
19
No connect
4K Camera signal USB_VBUS
13
18
+5V Power
Output from camera, used for HDMI
detect
14
17
Hot Plug Detect
Used by HDMI interface
15
16
No connect
16
15
No connect
17
14
No connect
18
13
GND
Video output from camera to encoder
19
12
TMDS Data2 +
20
11
TMDS Data2 -
21
10
GND
22
9
TMDS Data 1+
23
8
TMDS Data 1-
24
7
GND
25
6
TMDS Data 0+
26
5
TMDS Data 0-
27
4
GND
28
3
TMDS Data Clock+
29
2
TMDS Data Clock+
