Z3 Technology HE4K-DCK-10, Hardware Specification

Page: 17 / 25

17
HE4K-DCK-10
HARDWARE SPECIFICATION
CONFIDENTIAL DOC-USR-0100-01
____________________________________________________________________________________
Z3 Technology, LLC ♦ 100 N. 8th St. STE 250 ♦ Lincoln, NE 68508-1369 USA ♦ +1.402.323.0702
77 MIPI2_CKM 78 I2S_SCLK
79 GND 80 I2S_DAT
81 MIPI2_D0P 82 N/C
83 MIPI2_D0M 84 +3.3V
85 GND 86 +3.3V
87 MIPI2_D2P 88 +3.3V
89 MIPI2_D2M 90 +3.3V
Table 6 IFE PCB J4 Pin Out
7.1.5 J5 – Optional Auxiliary Power
It is possible to provide power to the FCB-ER8300 camera from an external source, using J5. In that
case, 0 Ohm resistor R9 must be removed to disconnect the internal power supply from J5 and J1.
When using internal power (from the I/O Jack PCB) R9 must be populated with a 0 Ohm resistor and
J5 must be left unconnected. J5 is normally not populated on the IFE board.
The pin assignment of J5 is shown in the table below.
Pin Signal
1 Ground
2 +12V
3 +12V
4 Ground
Table 7 IFE PCB J5 Pin Out
7.1.6 J6 – Optional FPGA Debug and Expansion
Connector J6 exposes I/O pins from the FPGA. It can be used for FPGA debugging or to connect
additional devices to the FPGA.
The pin assignment of J6 is as shown in the table below.
Pin Signal Pin Signal
1 No connection 2 +3.3V
3 DEB_CK, FPGA pin K4 4 DEB_D16, FPGA pin E2
5 DEB_D15, FPGA pin F3 6 DEB_D14, FPGA pin F1
7 DEB_D13, FPGA pin G2 8 DEB_D12, FPGA pin G1