10
DOC-USR-0264-05
____________________________________________________________________________________
Z3 Technology, LLC
♦
100 N. 8th St. STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
3.1
Supported Resolutions
The FVXK/FSDI-13A-RPS supports simultaneous output of up to four streams encoded at different
resolutions, frame rates and bitrates. Supported stream resolutions are:
4K (FV4K-13A only), 1080p (2MP), 1280x1024, 720p (1MP), 480p, 576p, 1024x576, 704x576,
640x480, 640x360, 420x380, 352x576, 352x288, 352x240, 320x240, and 320x180
In addition to scaling the resolution, the camera is also capable of scaling down the frame rate to save
bandwidth. Each channel can select from full frame rate, half frame rate, quarter or sixth frame rate.
For example, it is possible to configure a primary stream of 1920x1080 at 60 fps simultaneously with a
secondary stream at 480p at 10 fps.
For further details regarding supported streaming combinations, refer to the App Note “Ambarella
-based
CPU Encoder Resolution Limits” (DOC
-USR-0273-01).
4.0
QUICK START GUIDE
4.2
Before Attaching A Camera Block
Before connecting a camera block, a thorough review of section 7.0 and section 12.0 is required.
4.3
If You Have Received a System from Z3 with the Software Preloaded
To start working with the encoder, you can go straight to Section 13
.0 “RUNNING THE ENCODER”
on page
21. This section describes how to quickly stream UDP, RTP, RTSP or RTMP as well as record to a Micro-
SD card. Enabling Pro-MPEG Forward Error Correction (FEC), Zixi Feeder
™
or KLV data are also described.
4.4
If You Already Have a System from Z3 and Need to Update the Firmware
There are several options for updating the firmware on your RPS by following the instructions in Section
11.0:
RUNNING THE CODE YOU BUILT ON THE BOARD
4.5
If You are Ready to Start Development
Details on how to untar and build the code can be found in Section 9. A brief overview of the code itself
can be found in Section 10
Details on how to set up your system to access the code you have built can be found in Section 11:
RUNNING THE CODE YOU BUILT ON THE BOARD
Please Note:
Actual version numbers for your Z3 product may differ from those pictured in this document.
