Z-World OP7100, User Manual

Page: 47 / 122

OP7100 Hardware s 47
RE (Receiver Enable)
This bit controls the receiver: 1 Þ enabled, 0 Þ disabled. When this bit is
cleared, the processor aborts the operation in progress, but does not disturb
RDRF or the error flags.
MPE (Multiprocessor Enable)
This bit (1 Þ enabled, 0 Þ disabled) controls multiprocessor communica-
tion mode which uses an extra bit for selective communication when a
number of processors share a common serial bus. This bit has effect only
when MP in Control Register B is set to 1. When this bit is 1, only bytes
with the MP bit on will be detected. Others are ignored. If this bit is 0, all
bytes received are processed. Ignored bytes do not affect the error flags or
RDRF.
ASCI Control Register B
Control Register B configures the multiprocessor mode, parity, and baud
rate for each channel.
SS (Source/Speed Select)
Coupled with the prescaler (
PS
) and the divide ratio (
DR
), the
SS
bits select
the source (internal or external clock) and the baud rate divider, as shown
in Table 3-4.
CNTLB0
(02H) and
CNTLB1
(03H)
7 6 5 4 3 2 1 0
MPBT MP
/CTS
PS
PEO DR SS2 SS1 SS0
R / W R / W R / W R / W R / W R / W R / W R / W
Table 3-4. Baud Rate Divide Ratios
for Source/Speed Select Bits
SS2 SS1 SS0 Divide Ratio
0 0 0 ÷ 1
0 0 1 ÷ 2
0 1 0 ÷ 4
0 1 1 ÷ 8
1 0 0 ÷ 16
1 0 1 ÷ 32
1 1 0 ÷ 64
1 1 1 external clock*
* May not exceed system clock ÷ 40