17
Advanced Z-Wave Network Setups
Copying All Network and Device Information to A
Secondary Controller
You can add a secondary controller to your network and copy all of
your HSK-100’s network and device information to the secondary
controller by following the steps below.
Step
Setup Key
Setup LED Behavior
1
Press & hold
for 3 seconds
OK LED on
2
Place the two controller
close to each other
3
Type “8541” on the
setup number keypad
OK LED blinks once for
each number input
OK LED keeps blinking
after entering the 4-digit
4
Please make sure the
target controller is setup
to receive information.
(Refer to the target
controller user manual
for more information)
OK LED blinks once then
turns off
Replication completed
Note: If the replication is unsuccessful, the OK light turns off and the
error light will flash 6 times then turn off.
