Chapter 6 Troubleshooting Page 61
Chapter 6 Troubleshooting
This chapter provides troubleshooting procedures for basic problems with the R1 Extender.
Q 1. What if my R1 Extender fails to connect to the remote one?
•
Ethernet Link
: Check the availability of power to the bridge by observing the LED status on
the power injector or on top of the RJ-45 Jack of the unit.
-
Green: The R1 Extender is connecting to the backhaul network.
-
Off: The R1 Extender disconnects from the wired network, check whether the power cord
and Ethernet cables to the network and bridge are correctly connected.
•
Basic Configurations
: Mismatched basic settings among bridges are the most common
cause of connectivity fail. If the bridge does not associate with a remote bridge, check
whether options in each device are identical.
•
Security Settings
: Remote bridges attempting to authenticate to your bridge must support
the same security options configured in your bridge, such as WEP and WPA (2)-PSK. If your
bridge fails to associate with others, check whether the security settings are the same as
your bridge settings.
•
Antenna Alignment
: If the methods above are all checked to be correct, you can observe
and verify antenna alignment with RSSI value.
Q 2. What if I would like to reset the unit to default settings?
You may restore factory default settings in “
Backup/Restore Settings
” from “
Management
”.
Q 3. What if I would like to backup and restore my configuration settings?
You may do the backup by generating a configuration file or retrieve the settings you have backed
up previously in “
Backup/Restore Settings
” from “
Management
”.
Q 4. What if I can not open the Web-based management interface?
