Connect Up
Before installing the Ethernet cable with a waterproof RJ-45 connector, it is recommended that the
Cat-5 RJ-45 coaxial cable be used for the R1 Extender to power PoE connector.
1.
To connect to the hole labeled
PoE+Data
, open the black cover in advance by using a coin or a
slotted screwdriver and then screw in the body of the gland and tighten.
Figure 13 Connect Up – Step 1
2.
Slide the sealing nut to the RJ-45 cable from its middle breach and then insert the sealing into
the cable.
Slide the Sealing Nut from its Breach
Figure 14 Connect Up – Step 2
3.
Insert the RJ-45 connector and make sure that the locking tab snaps home.
Figure 15 Connect Up – Step 3
R1 Extender RJ-45 Port
4.
Screw the sealing on the gland and tighten.
Chapter 2 Hardware Installation Page 23
