YUNEEC TYPHOON H3, User Manual

Page: 13 / 49

Flight Control Sensitivity
Angle Mode EXP
< Flight Control Settings
up
down
0.07
turn left
turn right
0.00
forward/right
back/left
0.82
Reset params of the angle mode EXPO
Will Reset Exp Chart
No Yes
Reset
Flight Control Sensitivity function
This function can adjust the sensitivity of the control
to achieve the most user-friendly aircraft handling
feel
1.Click the settings button at the top right, find "flight
control settings" in the aircraft options, open this
menu, and then slide down to find the flight control
sensitivity function
2.Interface introduction
2.Interface introduction.
1
）
The curve on the left is the throttle Exp curve
；
2
）
The middle curve is the direction Exp curve
3
）
The curve on the right is the Exp curve shared by
aileron and elevator
4
）
The parameters of the current curve are marked
in the rectangular lattice below each curve
5
）
Reset button
3.Setting introduction
Power on the aircraft and remote control before set-
ting. Wait until the camera, aircraft and remote con-
trol are connected before using this function normally
1
）
For sliding setting, the three curves can be set by
sliding directly with fingers. Press and hold the curve
to be adjusted with fingers, then drag it up and down
until the curve reaches the desired shape, and then
release your hand to complete the setting.
3
）
Click Reset in the upper right corner and click Yes
in the pop-up box to restore all three curves to the
factory settings.
4 ） After setting, green √ will pop up on the screen,
indicating that the setting is successful and effective,
otherwise the setting will not take effect, please reset.
Flight Control Sensitivity
Angle Mode EXP
< Flight Control Settings
up
down
1.00
turn left
turn right
0.94
forward/right
back/left
0.91
Reset
2 ） Parameter setting: parameters under the coordinate system can be directly set for three curves to
achieve the setting purpose. Click the parameters under the curve coordinate system to be set, and
then the screen will pop up the keyboard. The user can input parameters as required to accurately
change the Exp curve. After setting, click Done to save the current setting.
NOTICE: the parameter settings range from 0 to 1.
1
）
The top slider sets the slider for attitude sensitivity
；
2
）
The middle slider sets the slider for brake sensitivity
；
3
）
The bottom slider sets the slider for Yaw sensitivity
.
4
）
Reset button.
3.Setting introduction
Before setting, power on the aircraft and remote controller, and wait for the camera, aircraft and
remote controller to be connected before use of this function.
13
Angle Mode EXP
up
down
1.00
turn left
turn right
0.94
forward/right
back/left
0.91
1 -
(
2 +
)
/
3 .
=
, 6
*
5 4
7 8
0
*
#
9
DONE
Reset