youngmangroup.com
Getting Started
7
Fitting the castors
To fit the castors carry out the following:
1. Carefully lay the fully collapsed main assembly (without platform) in a horizontal
position on the floor or on a bench.
2. Take a castor/stabiliser leg and slide the castor shaft into position on the main
assembly.
3. Push the red button on
RUNG 9
away from the castor and push the castor shaft
fully in and rotate until the castor is adjacent to rung 9.
4. Release the button and if necessary rotate it a little further until you hear the
lock-pin click into place, which locks the stabiliser in this position.
5. Push down on the stabiliser release lever and lift the stabiliser foot until it is fully
retracted, and then release the lever. This will allow the stabiliser leg to be clear
of the ground when the main assembly is returned to its upright position.
6. Repeat for the other castors and return the Tower to its upright position.
Deploying the Ground Stabiliser Legs
The ground stabiliser legs should be deployed when the Tower has been fully
erected at the required platform height.
1. To move it into place, unlock the castors and push it to the working position.
2. Lock the castors by pushing down on the locking lever with your foot.
3. Slide the red button closest to the ground stabiliser towards the centre of
RUNG 9
and rotate the stabiliser until it is near the required position. Release the
button and rotate a little further either way until you hear the locking mechanism
click in.
4. Deploy a ground stabiliser foot by pressing down on the Adjuster until the foot is
in contact with the surface. Turn the adjuster to tighten it to be in good contact
with the ground. Repeat for the other ground stabilisers as required or allowed.
5. Check that the castors and ground stabiliser legs are secure and locked before
using the Tower.
CASTOR
RELEASE
BUTTON
STABILISER FOOT
RELEASE LEVER
PART OF
FRAME
CASTOR
FOOT
CASTOR
LOCKING
LEVER
ADJUSTER
CASTOR
SHAFT
Summary of Contents for TTA02
Page 35: ...35 youngmangroup com Notes...