5.6.
Legrests
5.6.1.
Replace the actuator of a powered Legrest
Preparation
1.
Lift the legrest out of the wheelchair.
Procedure
1.
Remove the tie wraps and disconnect the
actuator cable from the legrest.
2.
Remove the screws and nuts (B and C).
3.
Remove the old actuator (A) from the
legrest.
4.
Put the new actuator in the legrest.
5.
Connect the actuator cable to the legrest.
6.
Put the connector cable into the groove of
the legrest and fasten the connector cable
with tie wraps.
Make sure that you leave enough free cable
length to let the actuator reach its full length.
7.
Check the functionality of the actuator.
B
A
C
5.6.2.
Replace the gasspring of a comfort legrest
Preparation
1.
Lift the legrest out of the wheelchair.
Procedure
1.
Remove the screws and nuts (B and C).
2.
Remove the old actuator (A) from the
legrest.
3.
Remove the lever block (D) from the
gasspring (A). The lever block is re-used
with the new gasspring.
4.
Put the level block on the new gasspring.
5.
Put the new actuator in the legrest.
6.
Check the functionality of the actuator.
B
A
D
C
Maintenance tasks & adjustments
Service manual - XP
25