
5.3.2.
Adjust the base height of the interface
The height of the interface can be adjusted in order to achieve the seat height as required
for the user.
Preparation
1.
Switch off the wheelchair via the button on the controller.
2.
Set both freewheel switches in 'Drive' mode.
3.
Remove the interface, including the seating system from the wheelchair, for easy
access.
Procedure
1.
Set the front side of the interface mounting
frames (B) to the required height.
2.
Set both brackets on the back side of the
interface mounting frames to the required
height.
3.
Fasten the screws.
4.
Put the seating in its original place.
5.
Make sure to lock the interface mounting
frames (screws A).
6.
Check if the wheelchair is stable in all
available positions for seat lift and tilt.
A
B
5.4.
Tilt-only interface
5.4.1.
Replace the Tilt Actuator (Tilt-only Interface)
Preparation
1.
Set the interface in the maximum tilted position for easy access.
2.
Prepare the wheelchair for maintenance. See section
5.1.
3.
Disconnect the interface cables from the controller.
Procedure
1.
Make sure that the interface is kept in the
tilted position. For instance by placing a
support.
2.
Disconnect the actuator cable.
3.
Remove the circlips (B) from the pivot (C) at
both ends of the actuator (A).
4.
WARNING!
Make sure that the tilt
mechanism is supported
safely.
Remove the old actuator.
5.
Put the new actuator into the tilt
mechanism.
6.
Connect the actuator cable.
7.
Make sure that the actuator cable can follow
the movement of the mechanism but that
the cable does not get jammed by the
mechanism.
8.
Check the functionality of the actuator.
A
C B
Maintenance tasks & adjustments
Service manual - XP
23