1.
Replace the power module.
2.
Switch on the controls.
The actuator LEDs 1 and 4 flash (C). This
indicates that the remote control and the
power module have different programs.
3.
Press the "+" button on the actuator
selection bar (D).
This way you select the backup program
from the remote control.
4.
Simultaneously press the horn button (B)
and the "+" button on the drive profile
selection bar (A) for 3 seconds.
This confirms the selection and the system
will beep when confirmed.
5.
Switch the controls off and on again to
activate the new settings.
1
2
3
4
A
D
B
C
For REM550:
1.
Replace the remote control.
2.
Switch on the controls.
The display shows a selection sequence for the backup program.
3.
Replace the remote control.
4.
Select the module that has NOT been replaced.
The backup program from this module will be used to automatically re-program the
new module.
Maintenance on the control system
34
Service manual - Alex
