9
JOHNSON CONTROLS
FORM NO.: 6U6K-B01E-NB-EN
SECTION 1 – GENERAL INFORMATION AND SAFETY
construction of units and provide CE Listing Label.
Fluorinated Greenhouse Gases
•
This equipment contains fluorinated greenhouse gases
covered by the Kyoto Protocol.
•
The GWP (global warming potential) of the refrigerant
(R410A) used in this unit is 2088.
•
The refrigerant quantity is stated in the Physical Data table of
this document.
•
The fluorinated greenhouse gases in this equipment may not
be vented to the atmosphere.
•
This equipment should only be serviced by qualified
technicians.
Responsibility for Safety
Every care has been taken in the design and manufacture of the
unit to ensure compliance with the safety requirements listed
above. However, the individual operating or working on any
machinery is primarily responsible for:
•
Personal safety, safety of other personnel, and the machinery.
•
Correct utilization of the machinery in accordance with the
procedures detailed in the manuals.
ABOUT THIS MANUAL
The contents of this manual include suggested best working
practices and procedures. These are issued for guidance
only, and they do not take precedence over the above stated
individual responsibility and/or local safety regulations.
This manual and any other document supplied with the unit
are the property of Johnson Controls which reserves all rights.
They may not be reproduced, in whole or in part, without prior
written authorization from an authorized Johnson Controls
representative.
MISUSE OF EQUIPMENT
Suitability for Application
The unit is intended for cooling/heating water or glycol
solutions and is not suitable for purposes other than those
specified in these instructions. Any use of the equipment other
than its intended use, or operation of the equipment contrary to
the relevant procedures may result in injury to the operator, or
damage to the equipment.
The unit must not be operated outside the design parameters
specified in this manual.
Structural Support
Structural support of the unit must be provided as indicated in
these instructions. Failure to provide proper support may result
in injury to the operator, or damage to the equipment and/or
building.
Mechanical Strength
The unit is not designed to withstand loads or stresses from
adjacent equipment, pipework or structures. Additional
components must not be mounted on the unit. Any such
extraneous loads may cause structural failure and may result in
injury to the operator, or damage to the equipment.
General Access
There are a number of areas and features, which may be a
hazard and potentially cause injury when working on the unit
unless suitable safety precautions are taken. It is important
to ensure access to the unit is restricted to suitably qualified
persons who are familiar with the potential hazards and
precautions necessary for safe operation and maintenance
of equipment containing high temperatures, pressures and
voltages.
Pressure Systems
The unit contains refrigerant vapor and liquid under pressure,
release of which can be a danger and cause injury. The user
should ensure that care is taken during installation, operation
and maintenance to avoid dam- age to the pressure system.
No attempt should be made to gain access to the component
parts of the pressure system other than by suitably trained and
qualified personnel.
Electrical
The unit must be grounded. No installation or maintenance
work should be attempted on the electrical equipment without
first switching power OFF, isolating and locking-off the power
supply. Servicing and maintenance on live equipment must only
be performed by suitably trained and qualified personnel. No
attempt should be made to gain access to the control panel or
electrical enclosures during normal operation of the unit.
Cooke Industries - Phone: +64 9 579 2185 Email: [email protected] Web: www.cookeindustries.co.nz
