JOHNSON CONTROLS
2
FORM 155.30-ICOM2.EN.UL
ISSUE DATE: 12/21/2018
This equipment is a relatively complicated apparatus.
During rigging, installation, operation, maintenance,
or service, individuals may be exposed to certain com-
ponents or conditions including, but not limited to:
heavy objects, refrigerants, materials under pressure,
rotating components, and both high and low voltage.
Each of these items has the potential, if misused or
handled improperly, to cause bodily injury or death. It
is the obligation and responsibility of rigging, instal-
lation, and operating/service personnel to identify and
recognize these inherent hazards, protect themselves,
and proceed safely in completing their tasks. Failure
to comply with any of these requirements could result
in serious damage to the equipment and the property in
IMPORTANT!
READ BEFORE PROCEEDING!
GENERAL SAFETY GUIDELINES
which it is situated, as well as severe personal injury or
death to themselves and people at the site.
This document is intended for use by owner-authorized
rigging, installation, and operating/service personnel. It
is expected that these individuals possess independent
training that will enable them to perform their assigned
tasks properly and safely. It is essential that, prior to
performing any task on this equipment, this individual
shall have read and understood the on-product labels,
this document and any referenced materials. This in-
dividual shall also be familiar with and comply with
all applicable industry and governmental standards and
regulations pertaining to the task in question.
SAFETY SYMBOLS
The following symbols are used in this document to alert the reader to specific situations:
Danger: Indicates a possible hazardous
situation which will result in death or
serious injury if proper care is not taken.
Warning: Indicates a potentially hazard-
ous situation which will result in possible
injuries or damage to equipment if proper
care is not taken.
Caution: Identifies a hazard which could
lead to damage to the machine, damage
to other equipment and/or environmental
pollution if proper care is not taken or
instructions and are not followed.
NOTE: Highlights additional information
useful to the technician in completing the
work being performed properly.
WARNING: External wiring, unless specified as an optional connection in the manufacturer’s product
line, is not to be connected inside the control cabinet. Devices such as relays, switches, transducers
and controls and any external wiring must not be installed inside the micro panel. All wiring must
be in accordance with Johnson Controls’ published specifications and must be performed only by a
qualified electrician. Johnson Controls will NOT be responsible for damage/problems resulting from
improper connections to the controls or application of improper control signals. Failure to follow this
warning will void the manufacturer’s warranty and cause serious damage to property or personal injury.
