![background image](http://html1.mh-extra.com/html/york/taurus-series/taurus-series_installation-and-operation-instructions-manual_947646012.webp)
C. FAN BUTTON
- By pressing this button each time the fan speed will change in the following sequence.
- This will be indicated by the LED lights on the Control Panel Key Pad.
LOW
MED HIGH AUTO LOW
-
There is no AUTO fan speed available in FAN mode.
D. SWING BUTTON
- Press this button to run on swing mode.
- Press it again to stop the louver in the preferred air distribution location.
E. TEMPERATURE UP & DOWN BUTTONS
- Each Press of these button will increase or decrease the set temperature by 1°C.
- The range of set temperature is 16°C - 30°C.
- Temperature setting is disabled in FAN mode.
F TIMER
BUTTON
- ON Timer can only be set when the system is OFF.
- OFF Timer can only be set when system is ON.
- Pressing of ‘ON’ or ‘OFF’ button will display the previous timer.
- Press UP or DOWN button to set the desired new timer.
- The range of timer is 0-24 hours.
- After time mode is set, TIMER LED light will be ON.
- Air conditioning until will turn ON or OFF automatically when the set number of hour have elapsed.
- Changing of ON/OFF state will cancel TIMER mode.
- Timer will cancel during power failure.
G 7. SEGMENT DISPLAY
- This display will show Room temperature during normal working.
- This display will show Set temperature when setting the temperature.
- This display will show Timer when setting the Timer.
- The following are various error diagnostic indications displayed on the 7 segment display.
11
FAULT CONDITION
Room temperature sensor failure
Indoor Coil Sensor Failure
Outdoor coil sensor failure (For Heat pump)
Compressor / 4WV failure (For Heat pump)
E1 on Display
E2 on Display
E3 on Display
E4 on Display
INDICATION
PROTECTIONS
INDICATION
H OPERATION MODE DISPLAY
- Shows the selected operation mode Cool, Fan Or *Heat.
- Following are the other indications available for the protections.
Indoor coil frost prevention
Outdoor auto defrost (For Heat pump)
COOL LED blinks continuously
HEAT LED blinks continuously