OUTDOOR UNITS
SAFETY
CAUTION
ELECTRICAL CONNECTIONS
GENERAL PRECAUTIONS
CRANKCASE HEATER
Before undertaking any work on the unit, make sure that the power supply has been disconnected.
INSTALLATION & OWNERS
MANUAL GUIDE
MINISPLIT CONDENSING UNIT
Models
MOC-MOH 07-65
For units fitted with crankcase heater, the heater MUST be on
for a minimum of 6 hours before starting compressor. Failure to
observe this precaution may result
in damage to the compressor or reversing valve.
All electrical wiring and connections must comply with local
standards. Power supply cord and interconnection cord used
must not be lighter than Polychloroprene sheated cord
(245 IEC 57 or H05RN-F).
Disconnecting device must have a contact separation of
at least 3 mm.
Check that the power supply available agrees with nameplate
voltage.
Use adequate line protection.
The unit must be grounded.
Installation and maintenance of this air conditioning system should only be carried out by trained and qualified personnel.
Regular maintenance operations such as cleaning the coils and air filters must be performed to keep the units in proper operating
condition.
EN/FR 035T83112-001
The units are shipped complete with a charge of R22 / R407C refrigerant sufficient for a piping length of 7.5 meters.
Four vibration absorbing mounts are delivered with each unit as well as a drainage elbow connector for condensate
drain connection (on heat pump models only).
From size 25 upwards, outdoor units are fitted with transport handles to facilitate handling and placement.
Every compressor is delivered with a sound-proofing wrap to reduce noise levels to a strict minimum.
The unit support plate is shaped in such a way that water produced during defrost operations on heat pump units is
collected at a single point where it can easily drained off. No accessory drain pan is required.
