![background image](http://html.mh-extra.com/html/york/jdoh-series/jdoh-series_original-instructions-manual_947511011.webp)
Model
120
182
100
080
4
3. Transportation and Handling
3.1
Transportation
Transport the product as close to the installation
location as practical before unpacking.
Do not put any material on the product.
Apply two lifting wires onto the outdoor unit,
when lifting it by crane.
3.2
Handling of Outdoor Unit
Do not put any foreign material into the
outdoor unit and check to ensure that none
exists in the outdoor unit before the
installation and test run. Otherwise, a fire or
failure, etc. may occur.
Fig. 3.1 Hanging Work for Transportation
Over 60
o
Wire Rope
0.7 to 1.0m
Do not remove the plastic
band or the corrugated
paper frame.
Pass the wire ropes
through each lifting
hole in the wooden
base as shown.
Hanging Method
When hanging the unit, ensure a balance of
the unit, check safety and lift up smoothly.
(1) Do not remove any packing materials.
(2) Hang the unit under packing condition with
two (2) ropes, as shown in Fig. 3.1.
Lift the outdoor unit in its factory packaging
with 2 wire ropes.
For safety reasons ensure that the outdoor
unit is lifted smoothly and does not lean.
Do not attach lifting equipment to the plastic
band or the corrugated paper frame.
Ensure the exterior of the unit is adequately
protected with cloth or paper.
When Using Handles
When manually lifting the unit using the
handles, pay attention to the following points.
(1) Do not remove the wooden base from
outdoor unit.
(2) To prevent the unit from overturning, pay
attention to the center of gravity as shown
in the below figure.
(3) Two or more personnel should be used to
move the unit.
Fig. 3.2 Handling of Outdoor Unit
Approx. 20
o
410
620
Wooden
Base
Handle
Center of Gravity
Fall Angle of
This Product
(kg)
Unit Gross Weight
179
Summary of Contents for JDOH Series
Page 2: ......
Page 19: ...JE 102SN JE 162SN ...