036-21371-001-B-0203
Unitary Products Group
3
APPLICATION FLEXIBILITY
OUTDOOR UNITS
These outdoor units are lightweight and can be installed on
almost any roof.
Units can be lifted using nylon straps with hooks at the holes
provided in the base rails, or they may be lifted with a forklift
through the slotted openings in the base rails.
A quality appearance and low sound levels make these units
suitable for most ground level locations.
Remember that during heat and defrost cycles, condensate
will drip from the underside of the unit coils and that this con-
densate will freeze when the temperature of the outdoor air is
below 32°F. A gravel bed or some other means of handling
this condensate may have to be provided.
INDOOR UNITS
These indoor units are shipped for vertical installation, but
may be field converted for horizontal applications by separat-
ing and repositioning the Blower Section. See product instal-
lation manual for for detail.
•
The Supply Air Plenum and the Return Air Grille acces-
sories can be used on either arrangement.
•
The Base accessory can only be used on the vertical
arrangement.
Units installed horizontally are designed for ceiling suspen-
sion. Four 3/8" - 16 weldnuts are provided in the angle sup-
ports on the front of the unit. Knockouts are provided in the
exterior panels for access to these weldnuts. The hanger
rods must be supplied in the field.
FIGURE 1: EA090 - OUTDOOR UNITS
5 FT
.
MIN.
FORK-LIFT
OPENINGS
TYPICAL
RIGGING
FIGURE 2: FA090 - INDOOR UNITS
